Strand Serie 200 Plus 24/48 - Fader

[discover]

Following the manual:

____
Playing Back a Submaster

p.18
Congratulations! You have recorded three Submasters.

Playing Back a Submaster

Set all the channel faders to 0%.
Press the SUBMASTER button.
It will turn red.
The flash button below any submaster in which information has been stored will be red.
You can output the submaster by raising that fader to 100%.

---> that has no effect
---> how can I use the fader to dim?

If you press the flash button you will flash the contents of the submaster to the level set
by the FLASH LEVEL fader.

---> I can only flash

 

____
Playing Back a LED Scene or Chase

p.42

(Recording an LED Scene or Chase)
----> I did succeed in this

Playing Back a LED Scene or Chase

To play back a scene or chase raise the relevant playback fader, the buttons under the faders with a scene or chase recorded in them will turn red. The chase will begin to run.

---> raising the relevant playback fader nor pushing the flash button does not run the scene

[Kazeja]

"Playing Back a Submaster"

I have not had the opportunity to operate this desk but is it possible the submaster may have a very long fade time associated with it?

[discover]

Thanks, Kazeja

I also assume it is a general basic seting.


I have followed up according to the manual:

• Fade Time p. 17
• Timed Fades
• It is possible to set a fade time between scenes by using the STEP RATE fader. 

 

Setting a Fade time below 0.05, which is [-------].
had no effect 😐



Any other ideas?

[Glyn Edwards]

Is there a playback / submaster  master fader anywhere that needs to be up but isn't?

[alistermorton]

You didn't have the step rate fader set to a long fade time when you recorded, did you?

[discover]

6 hours ago, Glyn Edwards said:

Is there a playback / submaster  master fader anywhere that needs to be up but isn't?

 

I have tried to set the "Step Rate Fader " (right)
to 0 which equals "Manual"

[discover]

 

 

Here two video I have made:

 

No fade:

https://youtu.be/fFQ2HNVgly8

 

No LED replay:

https://youtu.be/wVdYd00GZlI

 

What can I do now?

[Edward- Z88]

Hi @discover

Can you confirm the physical submaster fader you are using is working? Have you tried recording onto a different submaster fader?

[discover]

1 minute ago, Edward- Z88 said:

Hi @discover

Can you confirm the physical submaster fader you are using is working?

Yes, for the PRESET A (Fresnel Spot) I can confirm the physical submaster is working as it was working during programming the scene.

 

Quote

Have you tried recording onto a different submaster fader?

Yes, see all the red submasters here:
https://youtu.be/fFQ2HNVgly8

[Edward- Z88]

21 minutes ago, discover said:

Yes, see all the red submasters here:

Do all submasters behave the same, with only the flash buttons working?

[discover]

Yes