Yes, for the PRESET A (Fresnel Spot) I can confirm the physical submaster is working as it was working during programming the scene.
Yes, see all the red submasters here: https://youtu.be/fFQ2HNVgly8
Thanks, Kazeja
I also assume it is a general basic seting.
I have followed up according to the manual:
Fade Time p. 17
Timed Fades
It is possible to set a fade time between scenes by using the STEP RATE fader.
Setting a Fade time below 0.05, which is [-------].
had no effect 😐
Any other ideas?
Following the manual:
____
Playing Back a Submaster
p.18
Congratulations! You have recorded three Submasters.
Playing Back a Submaster
Set all the channel faders to 0%.
Press the SUBMASTER button.
It will turn red.
The flash button below any submaster in which information has been stored will be red.
You can output the submaster by raising that fader to 100%.
---> that has no effect
---> how can I use the fader to dim?
If you press the flash button you will flash the contents of the submaster to the level set
by the FLASH LEVEL fader.
---> I can only flash
____
Playing Back a LED Scene or Chase
p.42
(Recording an LED Scene or Chase)
----> I did succeed in this
Playing Back a LED Scene or Chase
To play back a scene or chase raise the relevant playback fader, the buttons under the faders with a scene or chase recorded in them will turn red. The chase will begin to run.
---> raising the relevant playback fader nor pushing the flash button does not run the scene
We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.