richard Posted February 1, 2015 Share Posted February 1, 2015 Hi All An odd Mac 700 (profile) problem. I am finding that if I snap the unit off from below 100% (say 50%) the unit is fading out - I would say in about 0.5 secs - while if I snap it out from 100% it is instantaneous. I'm pretty sure this is a setting on the unit but they are a pain to get out so would prefer to know which setting before I try and get at the thing - does anyone know what might be causing this? Thanks! Richard Link to comment Share on other sites More sharing options...
niclights Posted February 1, 2015 Share Posted February 1, 2015 Check the Effect Speed channel is set to zero. Assuming it is then there are two dimmer curve options on the unit PERS->DICU-> DIM1 = tungsten simulation, DIM2 = linear. Sounds like it might be on DIM1. Link to comment Share on other sites More sharing options...
richard Posted February 2, 2015 Author Share Posted February 2, 2015 Hmm, the DIM1 option sounds good - although it seems stupid that this only affects dimming to 0 from anything less than (and not including) 100% Thanks! Link to comment Share on other sites More sharing options...
tweety Posted February 2, 2015 Share Posted February 2, 2015 Please load the factory settings, power the fixture again and then select your settings in the PERS menu. This will mostly solve this sort of problems... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.