cameronaffleck Posted July 30, 2015 Share Posted July 30, 2015 Hi everyone Just wondering what your preferred method of cable management/identification is? We're currently using a barcoded system for all our physical pieces (lanterns/desks/etc), but need some way of keeping track of our cables. We have found something here. This is sort of what we're looking for, especially as they have their own barcodes etc, and can be wrapped around. What do you think? C Link to comment Share on other sites More sharing options...
Dave m Posted July 30, 2015 Share Posted July 30, 2015 To do what?For pat testing we use a robin tester and buy their labels, or at least use the labels that came with the machine. They fall off the actual lantern due to heat and a dusty surface, but have found that rolling them onto the cable works well.A few fall off in a year but not many. We used to use cleR heat shrink over paper labels but that involved taking the plug off the end.We also (years back) had heat shrink labels from concord with a corporate id but again only useful if making the leads up and adding I'd at the time. Link to comment Share on other sites More sharing options...
jonathanhill Posted July 30, 2015 Share Posted July 30, 2015 I use the Le Mark wrap-around barcode labels. No cheap, but totally customisable. The ones I bought have a logo and barcode on a 50mm section, with 100mm of clear self-adhesive that wraps round and secures the label. We use them on adaptors, cable and lanterns, applied around the yoke. The generic barcode reader connected to the new Megger appliance tester is reading them a dream, a year after first applying the labels. Link to comment Share on other sites More sharing options...
IRW Posted July 30, 2015 Share Posted July 30, 2015 I use the Le Mark wrap-around barcode labels. No cheap, but totally customisable. The ones I bought have a logo and barcode on a 50mm section, with 100mm of clear self-adhesive that wraps round and secures the label. We use them on adaptors, cable and lanterns, applied around the yoke. +1. Ours are very similar- I don't think they're quite as big as Jonathan's, but we supplement with some clear heatshrink over the cable/yoke as well- in the case of lanterns, it helps prevent the label going walkies, and in the case of cables, it stiffens that small section a little to help prevent the barcode flexing and cracking. Link to comment Share on other sites More sharing options...
pete_stagetex Posted August 7, 2015 Share Posted August 7, 2015 Depending on budget UPG Printers do similar wrap around labels to Le Mark. Last time I looked they came in a little cheaper and did 99% of the same job. Might be worth putting in a call. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.