Matt10V Posted December 16, 2012 Share Posted December 16, 2012 Alright, so my main issue is the lamp won't strike. The relay on the PCB board clicks and shows the little spark on L OFF so I know that's fine, however, the igniter does not even try to work. How can I tell if I have a bad igniter or if it is a short in the wiring between the ballast and where ever that goes too? Thanks, Matt Link to comment Share on other sites More sharing options...
greenalien Posted December 17, 2012 Share Posted December 17, 2012 The way most people diagnose problems with these sort of fixtures is to swap out the parts, one at a time, with a known good unit. Although this will usually find the problem, there is always the risk that the fault may damage any good parts, so proceed with caution. Link to comment Share on other sites More sharing options...
tonetski Posted May 8, 2013 Share Posted May 8, 2013 I stumble on your past issue about mac 250 lamp not striking, I have the same issue, did you resolve this? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.