louisetech Posted November 27, 2009 Share Posted November 27, 2009 We're using two of the ColorSpot 575E units at the moment. Both have been set to lamp on on power up and lamp on with DMX. Both units appear to have the same settings. One unit lamps on after power up, as expected, however the other unit doesn't always lamp on. On these occasions we have to lamp off and lamp on again on the unit itself. We're using a Congo desk to control the fixtures, and although the units respond to the lamp off command they don't appear to respond to a lamp on command, which is why we have set both units to lamp on automatically. Has anyone else had a similar problem with this type of moving light, and does anyone have a solution? I'm getting fed up of running up ladders just before a show to turn the lamp off and on again! Cheers Louise Link to comment Share on other sites More sharing options...
Sam_Lowers Posted November 27, 2009 Share Posted November 27, 2009 Are the units set to a timed lamp on?If you look in the ROBE guide you can set delays on the lamp strikes so that you dont push the power to hard when multiple units strike! Sam Link to comment Share on other sites More sharing options...
GreatBigHippy Posted November 27, 2009 Share Posted November 27, 2009 On the 250AT there is an option for it to try re-striking every 30secs I'd assume it was an option on the 575 also. May want to check it is enabled? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.