mkfs9 Posted February 5, 2009 Share Posted February 5, 2009 Hi all my first post here. I have a good understanding of most pa/live music. But have just purchased the above controller to use with my em26 speakers. Could anyone give me an idiots guide to initial set up, I am finding all the plug ins on the back a little confussing. E-bay no instructions. Thanx Link to comment Share on other sites More sharing options...
MarkPAman Posted February 5, 2009 Share Posted February 5, 2009 Hmmm ;) Matin's site is not working for me at the moment, but I did find this via the power of ;) Link to comment Share on other sites More sharing options...
Rob_Beech Posted February 5, 2009 Share Posted February 5, 2009 Jumpers 3 and 4 need to be in the 1st position. That's | : where the straight line represents the jumper. Jumpers 6 and 7 internally also need to be bridged for the EQ settings of the EM26. Are you using a sub or subs with the system? Link to comment Share on other sites More sharing options...
mkfs9 Posted February 5, 2009 Author Share Posted February 5, 2009 Jumpers 3 and 4 need to be in the 1st position. That's | : where the straight line represents the jumper. Jumpers 6 and 7 internally also need to be bridged for the EQ settings of the EM26. Are you using a sub or subs with the system? I have subs but not martin audio. could I still use them. 15 in 350watts rms 700 program. Link to comment Share on other sites More sharing options...
Rob_Beech Posted February 5, 2009 Share Posted February 5, 2009 Yes, you can. Bridge Jumpers 1 and 2 in position 3. Position 3 is where the top 2 pins from each section are bridged together. That SHOULD set things up properly. You may or may not need to adjust the subs trim which can be done with a screwdriver onto the PCB pots. You access this through the front of the unit I believe. Jumper 5 is the mono sum jumper for the sub but I assume you don't need this if you have more than 1 sub. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.