IanC
-
Posts
3 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Blogs
Downloads
Gallery
Store
Posts posted by IanC
-
-
Thanks for your questions, I have added some answers if that helps any
In what way do they struggle? They can't get through the full range of motion?With the fixture sat on its base. When they get to about 90o the weight of the head pull against the motors
How fast are they moving? Really fast?
They are moving at full speed
Do they have to move so fast?
Yeah the problem happens when they are moving at there default speed
Are the belts tight?
I was under the impression the two springs set the tension to the rear of the stepper motors, then you just nip the screws up tight
Do the motors move freely without power or is it a bit tight?
Motors run free with power off
Are all the sensors clean and free from obstruction?
Encoders are free and sensors are clean no errors on display
How do they react on a slow cue? Will they always find the right position?
they keep trying till they find the right position
Do they calibrate properly?
When the fixtures are powered up they go through the start up sequence fine
Do they work fine initially and then after some time do they start to get iffy? Or is it straight away?
they show the fault immediatly when moving fast
Cheers
Smiffy
-
I have 4 martin mac 600`s which all have to same fault. When moving at slow speed the tilt works fine, but if they are tilting at full speed the stepper motors struggle.
All toothed belts are in tact and I have swapped the pan and tilt driver chips over and the problem is still they same.
Has anybody else experienced this problem? if so help would be much appreciated
Mac 600 Tilt Issues
in Lighting
Posted
Thanks for your reply smiffy, im 100% the belts are not slipping.
I was wondering if one or both of the stepper motors could be faulty. Seem to be quite pricey so I was hoping to be certain since I dont have a working mac to try swapping the motors.