boardingbob

Thanks Don - I'll have a go at that too if the terminator doesn't smoke out the problem by itself. 

As all the kit is less than 3 months old I'm more than a little pxxxxed off that ANY of it is showing a fault so soon...

Thanks Bruce

A DMX terminator is a very sensible suggestion - will get one ordered asap. And yes, all configured as a single chain. Will interrogate the operator further to see if the 'faulty' units were the ones at the end of the chain or not. 

🙂

Hi all

My other half bought this desk, knowing its limitations, for a small schools tour where he just needs to do some very simple lighting cues with LED pars. I programmed it up for him and it has been working well - until yesterday.

During the show (run via pre-programmed cues on the faders) some of the lights 'froze' and refused to change colour/intensity. The colour LED backlights were the ones that froze whereas the warm/cool white ones doing the front light did not. All are directly wired to the desk. He rebooted the desk to no effect.

I suspect that there is a dodgy cable (or possibly lighting unit) somewhere in the run, but just wanted to check if anyone else has come across this as a desk issue. 

Cheers