Good afternoon folks, With the continued downtime I’m going through the stack of repairs I have, including a dodgy Betapack. Have tried to get in touch with Zero 88 but not had any luck. On DMX works perfectly. On manual (push buttons) works perfectly. But when using the external Level 6 controller, 1 of the channels misbehaves. When the said channel level on the Level 6 is at zero, the channel still outputs power. Raising the channel level towards full overrides this. Touching the case chassis causes a slight dimming of the channel output. All other 5 channels behave correctly. Have tried a different Level 6 controller and different control cable. Have opened the pack up and can’t see anything obvious, it’s immaculate inside. Any ideas? Thanks in advance.