Jump to content

Sound Lab snow machune


Emmett45

Recommended Posts

Hi all,

 

I have a fairly old Sound Lab snow machine. It was recently fired up for the first time in a long time and despite it being set to maximum the output wasn't fantastic.

 

Is there something recommended to flush through the machine in order to get rid of the old fluid and any residue?

Link to comment
Share on other sites

Take the sock off the front of the machine, inside there will be a little ariation stone/block on the end of a piece of pipe. Take that out (carefully) and clean it thoroughly as they often gunge up. Reassemble.

 

 

If that doesn't fix the flow then the pump probably needs replacing - snow/bubble liquid is very corrosive and gungy; left alone in a machine for a few months it can destroy seals and fur up metal components inside a pump.

Link to comment
Share on other sites

There was one that sat in unused our stores for quite some time that when it was brought out for a show it failed as the piping had also become very brittle and broke very quickly when a clean was attempted.
Link to comment
Share on other sites

Hi,

 

The little aeration block is actually missing off of the piping. This, I imagine, does not help matters.

 

 

Take the sock off the front of the machine, inside there will be a little ariation stone/block on the end of a piece of pipe. Take that out (carefully) and clean it thoroughly as they often gunge up. Reassemble.

 

 

If that doesn't fix the flow then the pump probably needs replacing - snow/bubble liquid is very corrosive and gungy; left alone in a machine for a few months it can destroy seals and fur up metal components inside a pump.

 

 

 

Link to comment
Share on other sites

The snow fluid is not great for the pump in storage. (I wish they'd make these things with peristaltic pumps!) The main pump issues are:-

 

Swollen o-ring in the piston seal which restricts movement.

General gunking up of the flow valves.

Tendency to block at the right angle on the pump outlet if it's that style of pump.

 

All these require careful disassembly of the pump to check (It has lots of bits and a spring!), but it's probably cheaper time and result wise to just replace the pump.

Link to comment
Share on other sites

Is there something that would serve as a suitable replacement? Filter from a smoke machine etc?

Not the end of the world but not helping either. The block ensures that the fluid spreads evenly around the inside of the sock, without it the fluid will tend to clump at the end of the sock producing less, wetter snow

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.