Jump to content

URGENT - Tecpro comms


Recommended Posts

Hi there folks

Currently having some problems with our comms system.

We're running Tecpro BP511s from an MS745 base station. We have 6 packs and headsets running on two chains (3/chain), but both running off of circuit A. There is no internal building wiring, it's all run off of XLR, (we're pretty sure there's a fault in Original comms wiring). All of this has worked perfectly well until 7;25 this evening when we were close to starting the show.

Every headset, on both chains, can hear themselves perfectly, and only hear everyone else faintly. The call/signal buttons don't work at all - it lights up for the person pressing the call button, but not on any other packs. This is true for belt packs communicating between each other, as well as the base station communicating with everyone else, and this is on both chains.

It was working fine before we opened the house, as some of the kids were talking to each other on it, and as I was on comms too I could hear them just fine!

We're a little stumped about what could break in such a short space of time. I did think it could be that someone had fiddled with the side tones and turned them down, but I've checked and it's fine, and that wouldn't explain why the signal/call function isn't working either. A cable fault could explain it, but even the pack directly connected to the station is having these problems with multiple XLRs, on both chains.

Any insight you can provide would be greatly appreciated!!!

Many thanks,Liz

 

 

 

 

Link to comment
Share on other sites

1417209673[/url]' post='512236']

It sounds as though the termination resistors in the power unit have gone short-circuit. The quickest way to check is to swap the circuits to the other channel on the MS745.

 

Thank you for the quick response Boatman! Will give that a go when the show ends http://www.blue-room.org.uk/public/style_emoticons/default/smile.gif

 

1417209673[/url]' post='512236']

It sounds as though the termination resistors in the power unit have gone short-circuit. The quickest way to check is to swap the circuits to the other channel on the MS745.

 

Tried this and I'm afraid we're still having the same problems! Is there any significance in the fact that when I plugged it in one of the B channels sparked? Seems a bit odd for comms to do....

Link to comment
Share on other sites

Sounds like the audio wire is shorted to ground somewhere. A bit of systematic fault finding is called for - use the call lights as a go/no go test. Disconnect each half of the system from the base station at a time and see which half is causing the problem. If it's there on both halves then the fault is in the base station. Otherwise disconnect each beltpack in turn and join the two ends of the loop together. If it is none of the beltpacks then it must be one of your XLR cables. Break the chain at each point working from the end back to the base. When the call lights start to work properly you've just disconnected the faulty length.

 

The spark is not unusual and is just the 24V charging up all the decoupling capacitors in the belt packs.

 

Hope this helps

Dave

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.